Filter
Top Products
Advanced Terminal Customization
126
C.3 - Remote Serial Number Update
The serial number is loaded into the flash by the factory for all NLynx
terminals which were shipped with version x0350 or above. If the terminal you
are using does not have the serial number loaded, it can be entered manually
on the terminal (see section 7.1) or via a special command.
Use SNMPadm 1.83.10 or above, to send a command to update the serial
number:
• discover the terminal you wish to update serial number
• right Click on the IP address of the terminal
• select the menu item Messages
• enter the following string into the message box. The number
TBB512345 will be used for this example:
$SET SERIALNO$ TBB512345