Filter
Top Products
3 - 7
MELSEC-F
SPECIFICATIONS3
3 - 7
3.5 List of Setting Items for Ethernet Modules
The following table lists the parameter setting items that are set using Ethernet Module.
: Must be set when the applicable function is used. : Set as needed : Setting is not required.
*1 The meanings of the abbreviations used in the table above are as follows:
MC: Communication using MC protocol
Mail: E-mail
Fixed: Communication using the fixed buffer
*2 Setting is not necessary if initial values are being used.
Parameter setting item Description of setting
Function and parameter setting
requirement (*
1
)
Reference
section
MC Fixed Mail
MELSOFT
Ethernet module settings
Settings for using the Ethernet module as a network
module.
Section 4.5
Operational settings
Set the common items between the modules.
These settings are required for the initial processing.
Section 4.6
Initial settings
Set the data communication timer values. *2 *2 *2 *2 Section 5.2
Set the DNS server's IP address. — — — Section 10.6
Open settings
Set up the open processing for connection in order to
perform data communication with the external device.
— Section 5.5
Router relay parameter Set the router relay of Ethernet. Section 5.3
E-mail settings Perform settings for sending e-mail. — — —
Section 10.6
Send mail address
setting
Set the destination mail address. — — —
POINT
Parameters set in FX Configurator-EN-L are saved in the Ethernet module's flash
ROM.