Mitsubishi Electronics fx3u Garage Door Opener User Manual


 
11 - 19
MELSEC-F
TROUBLESHOOTING11
11 - 19
11.4.4 Error codes stored in the buffer memory
When an error occurs at each data communication processing between the Ethernet
module and an external device, the error code (abnormal code) is stored in the buffer
memory of the Ethernet module. This section explains the contents of this type of
errors and error handling procedures.
The "Storage destination" column in the error code list indicates the buffer memory
where the applicable error code is stored.
The names used for the explanation indicated in the "Storage destination" column
corresponding to the buffer memory error code storage areas shown in the table
below. (Error codes whose storage destination is not written are returned to the
external device.)
Note that the buffer memory may store error codes of the messages returned from the
external device. For error codes not shown in this manual, refer to the manual of the
external device and check the returned messages.
Name used for explanation Buffer memory Buffer memory address
Initial Initial abnormal code area BFM#105
Open Open abnormal code area BFM#124...
Fixed sending Fixed buffer sending abnormal code area BFM#125...
Connection Connection end code/error log area BFM#126...
Error code Error code/end code area BFM#229...
E-mail log E-mail error log area BFM#23361...
Error code
(abnormal
code)
Description of error Error handling
Storage destination
Initial
Open
Fixed
sending
Connection
Error code
E-mail log
BFM#
105
BFM#
124
BFM#
125
BFM#
126
BFM#
229
BFM#
23361
0050
H
0051H
0052H
The content of these errors and the error handling for each error code is the same as the end
codes (0050 to 0060
H) returned to the external device.
Check the explanation of the applicable code shown in Subsection 11.4.1, and take actions
accordingly.
0054
H
0055H
0056H
0057H
0058H
0059H
005BH
Read and handle the error code and end code
area.
0060
H