Cornelius 10 Fan User Manual


 
40300381000
Trouble RemedyProbable Cause
ADJUSTMENT OF
DISPENSING VALVE SYRUP
FLOW REGULATOR DOES
NOT DECREASE TO
DESIRED WATER-TO-SYRUP
‘‘RATIO’’.
A. Dirty or inoperative piston or
cylinder in dispensing valve
syrup flow regulator.
A. Disassemble and clean
dispensing valve syrup flow
regulator.
DISPENSED PRODUCT
CARBONATION TOO LOW.
A. Carbonator CO
2
regulator out
of adjustment for existing
water conditions or
temperature.
A. Adjust carbonator CO
2
regulator
as instructed.
B. Water, oil, or dirt in CO
2
supply.
B. Remove contaminated CO
2
supply. Clean CO
2
system (lines,
regulators,etc.) using a mild
detergent. Replenish with a clean
CO
2
supply.
DISPENSED PRODUCT
COMES OUT OF
DISPENSING VALVE CLEAR
BUT FOAMS IN CUP.
A. Oil film or soap scum in cups. A. Use clean cups.
B. Ice used for finished drink is
sub-cooled.
B. Do not use ice directly from
freezer. Allow ice to become ‘‘wet’’
before using. (Refer to following
NOTE)
NOTE: Crushed ice also causes dispensing problems. When finished drink hits sharp edges of ice,
carbonation is released from finished drink.
DISPENSED PRODUCT
PRODUCES FOAM AS IT
LEAVES DISPENSING VALVE.
A. Carbonator CO
2
regulator
pressure set too high for
existing water conditions or
temperature.
A. Reduce carbonator CO
2
regulator
pressure setting as instructed.
B. Syrup over-carbonated with
CO
2
.
B. Remove soft drink tank quick
disconnects. Relieve tank CO
2
pressure, shake tank vigorously,
then relieve tank CO
2
pressure as
many times as necessary to
remove over-carbonation.
C. Tapered nylon washer inside
tube swivel nut connection
distorted from being
overtightened restricting syrup
flow.
C. Replace nylon washer. Make sure
washer is properly seated in
swivel nut.
ONLY CARBONATED WATER
DISPENSED.
A. Quick disconnect not secure
on soft drink tank.
A. Secure quick disconnect on soft
drink tank.
B. Out of syrup. B. Replenish syrup supply as
instructed.
C. Inoperable dispensing station. C. Repair dispensing station.
D. Dispensing valve syrup flow
regulator not properly
adjusted.
D. Adjust dispensing valve syrup
flow regulator (refer to Installation
Instructions provided with
dispensing station).