Filter
Top Products
3 Getting Started
EchoLife HG612 FTTC VDSL NTE
User Guide
3-6
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Issue 01 (2009-05-15)
in with atm.
.
list box.
, LAN802.1q, LAN802.1p, or NAT as
ntication mode provided by the ISP.
.
hoose Basic > LAN.
connection.
then set the corresponding parameters.
C TM Bridge
Step 1
ter VPI/VCI provided by the ISP.
3. S
4. C
Step 2
e drop-down list box.
the Service list drop-down list box.
.
pe drop-down list box.
or DHCP transparent transmission, WAN802.1q, WAN802.1p,
LAN802.1q, or LAN802.1p as required.
9. Click Submit.
Note
z The name of this PVC should beg
z The DSL link type of this ATM PVC should be EoA.
Select Ena3. ble for WAN connection.
4. Select a service from the Service list drop-down list box
5. Set Port binding to LAN1 or LAN2.
6. Select Route from the Connection mode drop-down
7. Set Connection type to PPPoE.
8. Select Enable for WAN802.1q, WAN802.1p
required.
9. Enter the user name and password provided by the ISP.
10. Select Enable for DHCP spoofing as required.
11. Select the authe
12. Select a dialing method, and then click Submit
Step 3
Set LAN parameters.
1. In the navigation tree, c
2. Set the IP address and subnet mask of the LAN
3. Select Enable for DHCP server, and
4. Click Submit.
3.4.5 onfiguring the A
Configure the ATM PVC.
1. In the navigation tree, choose Basic > ATM.
2. En
et DSL link type to EoA.
lick Submit.
Set WAN parameters.
1. In the navigation tree, choose Basic > WAN.
2. Select a PVC from the Layer2 interfac
Note
z The name of this PVC should begin with atm.
z The DSL link type of this ATM PVC should be EoA.
Select for WAN connection. 3. Enable
4. Select a service
from
5. Set Port binding to LAN1 or LAN2.
6. Select Bridge from the Connection mode dro
p-down list box
7. Select PPPoE_ Bridged or IP_ Bridged from the Bridge ty
8. Select Enable f