Filter
Top Products
1-99 3 21322L
I. LISTINGS AND CODE APPROVALS
Certification
The GC150 Series Vented Gas Fireplace has been
tested in accordance with the ANSI standard ANSI
Z21.50-1998
l
CGA 2.22-M98 and has been listed by
Warnock Hersey for installation and operation as
described in these Installation and Operating
Instructions. All components are A.G.A. or UL safety
certified.
Local codes
Check with your local building code agency prior to in-
stalling this appliance to ensure compliance with local
codes, including the need for permits and follow-up
inspections. This installation must conform with local
codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1-latest edition, in
the U.S.A. and the CAN/CGA B149, Installation Codes,
in Canada.
A manufactured home installation must conform with
the Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for
Manufactured Home Installations, ANSI Z225.1/NFPA
5 0 1 A .
Optional components
This gas appliance has been tested and listed for use
with the optional components listed on page 4. Many
optional components may be purchased separately
and installed at a later date. However, installation of
a remote control or fan kit will require electrical power.
To avoid costly reconstruction, electrical power should
be connected to the unit at the time of the initial fire-
place installation for possible addition of these acces-
sories at a later date.
Fuel
Any additions, changes or conversions required in
order for the appliance to satisfactorily meet the appli-
cation needs must be made by a Heatilator distributor
using factory specified and approved parts.
This product is manufactured to use natural gas and
is available in propane gas. In the event your appli-
ance must be converted to either natural gas from
propane or to propane gas from natural you must use
a proper conversion kit.
If any assistance is required during installation please
contact your local dealer or contact Heatilator
Technical Services Department, 1915 W. Saunders
Street, Mt. Pleasant, Iowa 52641.
HEATILATOR
®
is a registered trademark of
Heatilator, a Division of Hearth Technologies Inc.
GC150 SERIES DIRECT VENT GAS APPLIANCE
II. DESCRIPTION OF THE FIREPLACE SYSTEM
This HEATILATOR fireplace system consists of the
following:
1. Fireplace
2. Venting System
3. Termination
Optional components include:
1. Trim kits
2. Fan kit
3. Remote control
Note: Illustrations throughout these instructions
reflect typical installations and are for design pur-
poses only. Actual installation may vary slightly due
to individual design preferences. However, mini-
mum and maximum clearances must be maintained
at all times.
The illustrations and diagrams used throughout
these installation instructions are not drawn to scale.
Note: Operation of a direct vent fireplace
may be sporadic in high wind situations.
The GC150 is a vented gas fireplace. Combustion air is supplied from outside, not from inside the house as with
other types of fireplaces. While a significant amount of heat is created by the GC150, it is not intended to be and,
therefore, should not be used as a heater.
Tools and building supplies normal-
ly required for installation:
Tools: Building Supplies:
Saw Wall-finishing materials
Pliers Framing material
Hammer Fireplace surround
Phillips screwdriver High Temp. Caulking
Tape measure Material (300° F+)
Plumb line
Level
Drill and Bits
Square