Heat & Glo LifeStyle XLR-PB-AU Indoor Fireplace User Manual


  Open as PDF
of 70
 
59Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/12
Figure16.5RemoveValvePlateScrews
3. Set the valve bracket on the front lip of the rebox bot-
tom. Turn “off” the ball valve. Disconnect gas valve
from the gas ex ball valve assembly at the pressure
tting. See Figure 16.6.
Figure16.6RemoveValvePlate
4. Lift the valve assembly up and out to make necessary
service or repair.
5. Replace gasket before reinstalling the valve assem-
bly.
Figure16.7DisconnectGasValve
F. AccessThroughtheValveAssembly
The lower access cover panel is removable if nishing
material has not been previously installed.
Remove media tray, burner assembly, and base pan.
To access components:
1. Remove eleven screws around perimeter of valve as-
sembly that secure valve plate to the rebox bottom.
See Figure 16.5.
2. Lift the valve assembly from the back so that the gas
valve can clear the valve plate hole in the bottom the
rebox. See Figure 16.6.
VALVEASSEMBLY
GASKET
 previous next