Filter
Top Products
Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/1236
10
InstallingVentPipe(SLPPipe)
Figure10.2HighTemperatureSiliconeSealant(149°C(300°F)
minimumcontinuousexposure)
A. AssembleVentSections
To attach the rst vent component to the starting collars
of the appliance:
• Lock the vent components into place by sliding the pipe
section onto the collar.
• Align the seam of the pipe and seam of collar to allow
engagement. Rotate the vent component to lock into
place. Use this procedure for all vent components. See
Figure 10.1.
• Slide the gasket over the rst vent section and place it
ush to the appliance. This will prevent cold air inltration.
High temperature caulk (149 ° C (300 °F) minimum
continuous exposure) may be used to hold the part in
place.
• Continue adding vent components, locking each
succeeding component into place.
• Ensure that each succeeding vent component is securely
tted and locked into the preceding component.
Commercial,Multi-family (Multi-levelexceedingtwosto-
ries),orHigh-RiseApplications
For Installation into a commercial, multi-family (multi-level
exceeding two stories) or high-rise applications: All outer
pipe joints must be sealed with high temperature (149 ° C
(300 °F) minimum continuous exposure) silicone, includ-
ing the slip section that connects directly to the horizontal
termination cap.
• Apply a bead of silicone sealant inside the female outer
pipe joint prior to joining sections. See Figure 10.2.
• Only outer pipes need to be sealed. All unit collar, pipe,
slip section, elbow and cap outer ues shall be sealed
in this manner, unless otherwise stated.
Figure10.1AddingVentingComponents
WARNING! Risk of Fire or Explosion! DO NOT break
silicone seals on slip sections. Use care when removing
termination cap from slip pipe. If slip section seals are
broken during removal of the termination cap, vent may
leak.
Note: Align seams to engage pipe,
then rotate counterclockwise to lock