Filter
Top Products
Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/1254
Figure 15
Figure 14
Figure 16.
LOG NUMBER 6 (SRV2146-706): Place Log #6
onto grate and log #1. The groove on the bottom of the log
will engage the center grate bar and the other end of the
log will rest on Log #1, with the tip touching Log #7. The
points of contact are indicated by the circles located on
Log #6 and Log #7 in Figure 14. The log must NOT block
or sit directly over any burner ports.
LOG NUMBER 9 (SRV582-707): Place log #9 onto
Log #2 and Log #5. The “burnt area” of log 9 will face the
pilot side of the log assembly.
LOG NUMBER 8 (SRV2146-708): Locate notch
on Log #2 and notch on Log #3 indicated by the circles on
Figure 14. Place Log #8 so that it rests in these notches.
See Figure 15.
1
1
4
4
2
2
3
3
7
7
5
5
6
6
1
1
4
4
2
2
3
3
7
7
5
5
6
6
8
8
4
4
2
2
3
3
7
7
5
5
6
6
8
8
1
1
9
9
BURNT AREA
Figure 13
Figure 12
LOG NUMBER 5 (SRV2146-705): Place Log #5
from side of unit where pilot is located on your right side.
Place log so the front log notch engages the center grate
tine as shown in Figure 12 and the right side of log rests
on the notch in Log #4. See Figure 11. The notch is visible
in Figure 11. The log must NOT block or sit directly over
any burner ports.
LOG NUMBER 7 (SRV2146-707): Log #7 rests
on the notch on top of log #1 and the notch on top of log
#4. See Figure 13. The points of contact on Log #1 and
Log #4 where Log #7 rests are indicated by the circles in
Figure 10.
3
3
2
2
1
1
4
4
5
5
1
1
4
4
2
2
3
3
7
7
5
5
FRONT LOG
NOTCH