Filter
Top Products
Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12 49
F. Install Light Bulbs
Note: Light bulbs are shipped in the installation manual bag.
Ember Lights
1. Remove ember basket by lifting it from fi replace. There
is one metal tab on each end of the ember box that
engages slots in the ember basket. See Figure 14.9.
Figure 14.9 Ember Basket
2. Install two 20 watt halogen bulbs per side. See Figure
14.10.
NOTICE: Grip bulb by the porcelain base only. DO NOT
TOUCH glass bulb. Touching the bulbs with fi ngers will
greatly reduce the operating life of these bulbs.
Figure 14.10 Ember Light Bulb Installed
3. Reinstall ember basket over the ember box by inserting
the tabs on the ember box in the slots on the ember
basket. See Figure 14.9.
Accent Lights
1. Remove the screw that secures the two bottom sheet
metal refractory standoffs that are installed around
the left and right accent light assemblies. See Figure
14.13.
Figure 14.13 Accent Light Bulb Installation Completed
2. Install the two accent lights by removing (2) screws
that hold the light housing to the fi rebox bottom. Install
bulb by inserting the 2 pins on the bulb base into the
2 holes in the socket. See Figure 14.11 and Figure
14.12.
Figure 14.11 Light Housing Removal
Figure 14.12 Light Housing Removed, Bulb Installed
SCREWS
3. Reinstall accent light cover to light socket assembly
and install with two screws to fi rebox bottom.
4. Reinstall the two bottom sheet metal refractory stand-
offs with one screw each. See Figure 14.13.
SHEET METAL
SHEET METAL
REFRACTORY STANDOFF
REFRACTORY STANDOFF