Filter
Top Products
25
LIGHTING AND OPERATION
COOKING BURNER OPERATION
The cooking burner on your FireLuxe functions like a cooking burner on any conventional kitchen range.
A battery-powered flame-sensing automatic ignition system lights the burner when you depress the control
knob and rotate counterclockwise to the High (H) position. You will hear a clicking sound and can observe
the spark arcing from the igniter electrode to the burner body. Once the burner is lit, the flame sensor will
shut off the spark. If, for any reason, the sensor does not detect a flame, the igniter will automatically re-
sume sparking until the flame is detected again.
The flames should be blue and evenly distributed around the perimeter of the burner. See the illustration
below.
Adjust the flame for the desired heat level by rotating the knob. To turn the burner off, rotate the knob
clockwise to the OFF position. (See fig. 4 on page 24.)
Refer to the lighting instructions on page 24 and the lighting and operating instructions on the permanent
metal label attached by cable to the rear of the stove.
WARNING: THE COOKING BURNER IS FOR ATTENDED USE ONLY. DO NOT LEAVE UN-
ATTENDED FOR ANY REASON.
WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF HIGH
SURFACE TEMPERATURES AND SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING
IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY ARE
IN THE SAME ROOM AS THE APPLIANCE. CLOTHING OR OTHER FLAMMABLE MATE-
RIAL SHOULD NOT BE PLACED ON OR NEAR THE APPLIANCE.
WARNING: BASED ON SAFETY CONSIDERATIONS, THE COOKING BURNER FLAME
SHOULD BE ADJUSTED SO IT DOES NOT EXTEND BEYOND THE EDGE OF THE COOK-
ING UTENSIL.
WARNING: BASED ON SAFETY CONSIDERATIONS, DO NOT USE THE COOKING
BURNER FOR SPACE HEATING UNDER ANY CIRCUMSTANCES.
PILOT AND MAIN BURNER OPERATION
Follow the lighting instructions on pages 23 – 24. When the pilot is lit and operating properly, it should
look like the illustration above. One flame will be directed at the pilot thermocouple and the other will be
emanating toward the burner. If the pilot flames do not resemble the illustration above, see the instructions
on page 26 for pilot flame adjustment.
After the main burner ignites and has been in operation for a few minutes, the flames should look like the
illustration on the top of page 26. Flame height will vary depending on the firing rate but flames should be
burning in all of the indicated areas.
CORRECT PILOT FLAMES
CORRECT COOKING BURNER FLAMES
THERMOCOUPLE FLAME
BURNER IGNITION FLAME