Filter
Top Products
17
ASSEMBLY
When correctly placed, the logs and embers will look like the illustration below.
LATCHING DETAIL-
PULL FORWARD AND
DOWN TO HOOK LATCH
OVER GLASS FRAME
After the logs and embers have been placed, the next
step is to replace the glass panel and frame. Carefully
pick up the glass and glass frame assembly by grasp-
ing the sides of the frame and using your thumbs and
fingers to hold the glass in place within the gasket and
frame.
With the glass frame (and glass) at a slight angle
(leaving room for your fingers between the frame and
the firebox) insert the bottom edge of the frame into
the frame retainer located on the bottom front of the
firebox. Take care to center the frame from left to
right. Once the bottom edge is in place, move your
fingers out of the way and press the top of the frame
against the firebox while pushing down to be sure the
frame is fully engaged in the frame retainer. Hold the
frame in place with one hand and engage the three
glass frame latches by pulling out and down while
hooking them over the frame.
Top or Rear Vent
The FireLuxe has provisions for either top or rear venting but is shipped from the factory set-up for top
venting. The rear position is sealed with a special cover plate. If your installation requires rear-venting,
you will need to reverse the positions of the starter section and the cover plate.
Remove the four screws that secure the vent starter section flange to the stove and remove the starter.
There are two ceramic fiber gaskets that seal the starter to the stove. These gaskets are very important!
Take care in handling these gaskets as they are somewhat fragile and will tear. Remove the vent cover plate
from the rear of the stove following the same procedure as the starter. Install the cover plate on the top vent
opening.