Filter
Top Products
Set Up Voice
The Omni IIe can be set up to speak descriptive names such as "FRONT DOOR" for control zones, units, buttons, codes,
temperatures, areas, and messages. These names will be spoken over the telephone along with the item number that is normally
spoken. Voice descriptions for messages can be spoken over a speaker when used with the HAI Two-Way Audio Module.
To enter the Set Up Voice menu, from the Setup menu, press the 8 (VOICE) key.
SET UP VOICE
1=CTRL 2=ZONE 3=BTTN
↓
4=CODE 5=TEMP 6=AREA
8=MSG
↑
Select the item that you would like to give a voice description. Use the arrow keys to scroll through the list of names.
To enter a voice description, enter the code shown next to the voice description in Appendix C for each description (word or
group of words), then press the ' # ' key. After you have entered the complete description for each item (unit, zone, button, code,
temperature, area, and message), press the ' # ' key twice. You may enter up to six (6) descriptions (word or group of words) for
each unit, zone, button, code, temperature, area, and message.
UNIT 1 VOICE:
↓
UNIT 1 VOICE:
144 109
↓
When Unit 1 is spoken over the phone, the Omni IIe will say, "UNIT 1 - PORCH LIGHT".
Set Up Address
The final setup item is accomplished over the telephone. This is the address that the system says when it dials out in an
emergency. Your voice will be recorded on computer chips in the Omni IIe controller and saved to be played back in the
emergency message when the system dials out for an alarm.
Pick up an inside phone and press the ' # ' key on the telephone within 5 seconds of picking up the phone. The Omni IIe will
respond with a menu. Press 8 on the telephone keypad, then 8. The unit will say "ADDRESS IS:" then the Omni IIe will play
back the message stored in the Address memory if one has been entered by your installer.
To record your address, Press 9, then enter the Master Code. The Omni IIe will say "RECORD ADDRESS", then BEEP. In a
normal tone of voice, say your name and address and any helpful information for locating your house.
"THE JONES RESIDENCE, 1234 JOHNSON STREET, CORNER OF JOHNSON AND THIRD STREET"
The unit will beep after 8 seconds, then play the address back to you. If you are not happy with the sound, re-record by pressing 9
and the Master Code. If you would like to hear the address again, press 8 for Play Address.
If you accidentally press 9 but have not entered your master code and do not wish to record a new address, simply hang up the
phone. The address can be recorded from a local (in house) phone or a remote phone. We suggest using a local phone for higher
sound quality.
¾ When the Omni IIe says "record address - beep" any previous address recorded on your system is erased. Always verify
that you have your name and address in your system if you have entered this function.
¾ When recording the address, do not press any touch-tone keys on your phone until the second beep, indicating that
recording is complete. This will cause improper operation when the system dials out. The Omni IIe will think that the
tone is a code being entered by the called party and it will stop talking.
Page 78