Filter
Top Products
Advanced Control Programming (ACP)
Your Omni IIe can be programmed to do automated control and security functions on a time schedule or in response to an event
occurring in the system. You may program the following items:
• Unit Numbers: On, Off, On for time, Off for time, Dim, Brighten, Dim for time, Brighten for time, Level, and Scene
• Settings for HAI Communicating Thermostats
• PESM control: On, Off, On for time, Off for time, and Heat and Cool setback temperatures
• Temperatures: Low and High temperatures
• All lights On, All Off
• Security modes Off, Day, Night, Away, Vacation, Day(Instant), and Night(Delay) and bypass and restore zones
• Buttons (Events)
• Messages: Show, Log, Clear, Say, Phone, and Send
The Omni IIe executes programs:
• Once at a certain time on a certain date (One-Time Program)
• On a certain date every year (Yearly Program)
• Repeatedly (Repeating Programs)
• In response to an event (Button Programs)
You can also specify 2 conditions in each program, so that they only run under certain circumstances.
Every line of programming in the Omni IIe controller consists of three pieces. Each line must have at least an event (when) and a
result (command). The "&IF" statement (condition) is optional in all programming lines.
The program may specify up to 2 conditions that must be true for the program to execute. When programming from the console,
only 1 condition can be selected. If 2 conditions must be specified for a single program line, it must be entered using the PC
Access Software.
Each program can be set up to execute at a certain time of day or on the occurrence of a particular event in the system. When this
time or event occurs, the programmed action will be taken if, and only if, the specified condition(s) is also true at that time.
The Program menu allows you to add, review, change, and delete automation programs. To enter the Program menu, from the
Setup menu, press the 3 (PROG) key.
SET UP PROGRAMS
1=ADD 2=SHOW 3=DELETE
1 = Add Programs
The 1 (ADD) key is used to add new automation programs to the system. When you press the 1 (ADD) key, the Edit Program
menu is displayed which allows the various parts of a program to be specified - See Edit Program. You may edit each part of the
program as specified under Edit Program. Press the ' # ' key at the Edit Program menu to show the newly entered program.
Press the ' # ' key again to save the program, or press the ' * ' key to return to the Edit Program menu to cancel entry of the new
program and return to the Set Up Programs menu.
Once the new program is entered, the display will return to the Set Up Programs menu.
2 = Show Programs
The 2 (SHOW) key is used to review, edit, and delete existing programs. From the Set Up Program menu, press the 2 (SHOW)
key. The display prompts you to specify which program to be reviewed.
1=CTRL 2=SEC 3=BTTN
4=ALL 5=TEMP #=EVERY
Page 54