If the ' 0 ' (ALL) key had been selected, the display will show:
DISARM ALL AREAS
ENTER CODE: #=AREA
As the four-digit code is entered, "X" characters are echoed after the "ENTER CODE:" prompt.
If the Master code or a valid code is entered, the console will beep one time and Area 2 will be disarmed.
Even if Auto Bypass is enabled, the system will not arm another area if any zones in that area are not ready. If any zone in Area 2
is not ready (open), after you enter the code, the console will beep three times and display "AREA 2" on the top line, and "ZONE
NOT READY" on the bottom line.
AREA 2
ZONE NOT READY #=RETRY
In order to arm Area 2 from a console in Area 1, you must first secure or Bypass any zones in AREA 2 that are "Not Ready".
Press the ' # ' key to retry the arming process.
To Bypass or Restore a zone in Area 2 from a console in Area 1, or viceversa, it is first necessary to "go to" that area.
GOTO Area
From the security menu, press the # (GOTO) key on the console keypad.
AREA:
ENTER AREA
↓
The Area number can be entered followed by the ' # ' key, or use the arrow keys to scroll through a list of areas. Once the area is
selected, you are prompted to enter your code:
GOTO AREA 2
ENTER CODE
The console (AREA 1) will now be temporarily assigned to the selected area (AREA 2) if a valid code for that area (AREA 2) is
entered. All security and control commands will now operate on the selected area (AREA 2), just as if you were physically at a
console assigned to that area (AREA 2). All status displays will show the status of the selected area.
The top line of the display will show the name and security mode for that area.
Use the "go to" function again to return to the area normally assigned to that console (AREA 1). The console will automatically
return to its normal area after three minutes of inactivity at the console.
Page 14