The unit is displayed and the display prompts for the state of the unit:
IF Porch Light:
0=OFF 1=ON
Program Security Mode Conditions
Press the 2 (SEC) key to specify that the program should only execute if the security system is armed in a particular mode. Select
the security mode from the following menu:
0=OFF 1=DAY 2=NIT 3=AWY
4=VAC 5=DYI 6=NTD
Next, select whether the system is considered in the specified mode during the exit delay:
INCLUDE EXIT DELAY?
0=NO 1=YES
If area arming is being used, the display will then prompt you to specify the area.
Program Zone Conditions
Select the 3 (ZONE) key to specify that the program should only execute if a specified security zone is either Secure or Not
Ready. The display prompts you for the zone number:
ZONE:
ENTER ZONE
↓
Enter the zone number followed by the ' # ' key, or use the arrow keys to select the zone.
The zone will be displayed and you will be prompted for the state of the zone:
IF Front Door:
0=SECURE 1=NOT RDY
Program Time Clock Conditions
Select the 9 (TIME) key to specify that the program should only execute if a specified Time Clock is either On or Off. The
display prompts you for the Time Clock number:
ENTER TIME CLOCK:
1-3
Enter the Time Clock number followed by the ' # ' key.
Next, specify the state of the time clock:
IF TIME CLOCK 1:
0=OFF 1=ON
Program Other Conditions
Select the # (OTHER) key to select a condition from a list of other conditions.
SELECT CONDITION:
NONE
↓
Page 67