Home Automation INC. Omni IIe Indoor Furnishings User Manual


 
HAI RC-Series Thermostats
The following control actions are allowed for HAI Communicating Thermostats:
Set heating setpoints
Set cooling setpoints
Set system mode (Off / Heat / Cool / Auto)
Set fan (On / Auto)
Turn hold On and Off
NOTE: Not all actions are applicable to every type of thermostat.
To enter the temperature menu, from the top-level display or from the main menu, press the 5 (TEMP) key on the console keypad.
You will be prompted with the first named temperature zone (i.e. Upstairs). The temperature zone can be specified by entering
the temperature zone number followed by the ' # ' key, or by pressing the arrow keys to scroll through the list of temperature
zones. Press the ' # ' key when the desired temperature zone is shown.
Press the ' 0 ' key to select all HAI Thermostats. This is a simple way to broadcast the new Heat or Cool setting or change the
system mode, fan mode, or hold mode of all HAI thermostats in your system. Temperature zones 1-4 are for HAI thermostats.
TEMPERATURE:
ENTER TEMP ZONE 0=ALL
After the ' # ' key is pressed, a menu appropriate for the type of temperature zone is shown. For Celsius temperatures, press the
' # ' key prior to entering the temperature to make the number negative. The Celsius temperature may also be specified in 0.5
degree steps, if three numeric digits are entered. The third digit adds a .5 to the first two digits, if it is anything other than zero.
Enter a leading zero, if necessary.
For HAI heat/cool thermostats:
Upstairs
1=MODE 2=HEAT 3=COOL
Upstairs
4=FAN 5=HOLD #=STAT
To change the system mode on a thermostat, press 1 (MODE). A menu presenting options appropriate for that type of thermostat
is then displayed.
For heat/cool thermostats with auto changeover:
Upstairs MODE
0=OFF 1=HEAT 2=COOL
Upstairs MODE
3=AUTO
To change a temperature setting, press 2 (HEAT), 3 (COOL), or 2 (TEMP) as appropriate:
Upstairs HEAT
ENTER TEMPERATURE:
Upstairs COOL
ENTER TEMPERATURE:
Upstairs TEMP
ENTER TEMPERATURE:
Enter the desired temperature then press the ' # ' key.
The fan control on a thermostat may be switched between on and auto by selecting 4 (FAN) from the temperature menu:
Page 30