Filter
Top Products
Reference Manual
300560EN, Rev AA
May 2011
4-11
Rosemount 2230
Section 4. Configuration and Operation
4.6.3 Units for Display In the Units for Display menu, you can see which measurement units that are
used for the displayed variables. The available measurement units are listed
in Table 4-2 on page 4-12.
To change measurement unit:
1. In View Mode, press <Menu> <Options> <Units for Display>:
Figure 4-17. The Units for
Display menu
2. Use the up and down arrow softkeys to navigate to the desired variable
menu item. In the example above, the Length variable was chosen.
3. Press the softkey to continue to the list of options for the selected
variable.
Figure 4-18. Select unit for
Length
4. Use the up and down arrow softkeys to navigate to the desired
measurement unit.
5. Press the <OK> softkey to select the unit and return to the Units for
Display list.
See Table 4-2 for a list of available measurement units.