Filter
Top Products
Reference Manual
300560EN, Rev AA
May 2011
Rosemount 2230
4-8
Section 4. Configuration and Operation
4.6.1 Variables In the Select Variables menu, you can choose which variables to present in
View Mode. The following options are available:
• 2410 Tank Pos 1-10 lets you configure a common set of variables to
be presented for all tanks
• 2410 Tk Pos 1, 2, 3... lets you configure variables individually for each
tank
For a list of available variables see Table 4-1 on page 4-9.
Select Variables Menu
The Select Variables menu allows you to select variables to be displayed in
View Mode. Option “2410 Tank Pos 1-10” can be used to specify a common
set of variables to be used for all tanks connected to the same 2410 Tank
Hub. In addition to this you can configure tanks individually by specifying a
unique set of variables for each tank. Note that the individual configuration will
be added to the configuration that is common for all tanks.
For a list of selectable variables, see Table 4-1 on page 4-9.
To select variables:
1. In View Mode, press <Menu> <Options> <Variables>.
Figure 4-13. The Select
Variables menu
2. Use the up and down arrow softkeys to navigate to the desired 2410
Tank Position item.
3. Press the <OK> softkey to continue to the Selected Variables list.
Figure 4-14. The Select
Variables Custom option
4. In the Select Variables list, choose the variables you wish to show in
View Mode.
5. When finished, press <OK> to return to View Mode.