Filter
Top Products
www.desatech.com
111245-01B 25
Figure 44 - Installing Crossover
Logs (#4 & #5) [CGEFP Logs Shown]
Pins
Crossover
Log (#5)
Crossover
Log (#4)
INSTALLING BATTERY INTO
REMOTE
1. Locate slot at bottom of remote control (see
Figure 45). Firmly insert tool such as a small
screwdriver, butter knife or dime into the slot
and lift up to remove cover.
2. Insert supplied battery into remote control.
Positive and negative are marked inside re
-
mote control casing. Note: Remote will not
function if battery is not installed correctly.
3. Slide tab on cover into remote housing and
snap cover back into place.
IMPORTANT: Use only A23 12 volt battery in
remote. DO NOT use AAA battery.
Positive
Figure 45 - Installing Battery
Negative
Tab
Cover
Remote
Control
Slot
A23 12
Volt Battery
Figure 46 - Installing Fireplace Screen
INSTALLING SCREEN
Install fireplace screen by slipping notches of
fireplace screen over screws on front of fireplace
(see Figure 46).
Notches
Screws for
Mounting
Screen
INSTALLATION
Continued
OPERATING FIREPLACE
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which lights auto-
matically when using the supplied wall switch
or remote control. If you have a power outage,
the pilot may be lighted by hand with push-
button piezo ignitor. When lighting the pilot,
the following warnings must be followed.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch;
do not
use any phone in your building.
• Immediately call your gas supplier from
a neighborʼs phone. Follow the gas
supplierʼs instructions.
• If you cannot reach your gas supplier, call
the fire department.
C. Electric Power Outage Only: Use only your
hand to turn the manual override handle
on the gas control knob. Never use tools. If
the knob will not turn by hand, donʼt try to
repair it, call a qualified service technician
or gas supplier. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.