Filter
Top Products
www.desatech.com
111245-01B 23
Figure 37 - Minimum Mantel Clearances
for Built-In Installation
Supplied
Firebox
Hood
Must Be
Used at
All Times
Wire-mesh
Screen
Firebox
Noncombustible
Material May
Project Off this
Surface above
the Firebox
Hood
Mantel Shelf
13"
16"
19"
21"
2
1
/2
"
6"
8"
10"
Note: All vertical
measurements are
from top of fireplace
hood opening to
bottom of mantel
shelf. These minimum
clearances replace any
other recommended
clearances supplied
with your ANSI Z21.11.2
approved gas logs.
Wa
ll board or facing
material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments or
other similar projec-
tions off of the facing
material.
Framing
Material
INSTALLATION
Continued
ASSEMBLING AND ATTACHING
OPTIONAL BRASS TRIM
(Included with Mantel Accessory)
Note: The instructions below show assembling
and attaching brass trim to fireplace.
1. Remove packaging from three pieces of
brass trim.
2. Locate four brass screws, two adjusting
plates with set screws and two shims in the
hardware packet.
3. Align shim under adjusting plate as shown in
Figure 38.
4. Slide one end of adjusting plate/shim in slot on
mitered edge of top brass trim (see Figure 38).
5. Slide other end of adjusting plate/shim in slot on
mitered edge of side brass trim (see Figure 38).
6. While firmly holding edges of brass trim to
-
gether, tighten both set screws on the adjusting
plate with slotted screwdriver.
7. Repeat steps 1 through 6 for the other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place the
assembled trim onto fireplace cabinet. Align
hanging notches on trim with hanging screws
on side of fireplace (see Figure 39). Push trim
firmly into place, sliding hanging notches over
hanging screws.
Figure 38 - Assembling Brass Trim
Slot
Mitered Edge
Slot
Shim
Set Screws
Adjusting
Plate
Side Brass
Trim
Top Brass Trim
Figure 39 - Attaching Brass Trim to
Fireplace
Trim
Hanging
Screws
Assembled
Brass Trim
Hanging
Notches
on Trim
Figure 40 - Installing Hood to Firebox
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 40.
Use 3 Phillips screws provided.