Filter
Top Products
Version 1.0b
7
INGLENOOK PARTS REMOVAL
Once cleaning or installation of the Inglenook solid fuel fireplace is complete, it is time to remove some
parts that will not be required for gas operation. FIGURE 1 identifies each of these parts and TABLE 1 lists
each of these parts along with the Country Flame Part Number. Use TABLE 1 as a check sheet when
removing these parts. Once removed, the wood burning parts need to be properly packed and stored away
for potential future use. The homeowner should ensure proper storage of the Inglenook solid fuel parts.
Future conversion of the Inglenook gas log system back to a solid wood fuel system will require the use of
these parts. If the parts are lost, damaged, or worn, contact Country Flame or an authorized dealer to obtain
new parts before attempting wood burning operations in the Inglenook fireplace again.
FIGURE 1: INGLENOOK SOLID FUEL PARTS REMOVAL
TABLE 1 should be used as a checklist to ensure all solid (wood burning) fuel parts are removed. Once
removed, these parts should be stored for potential future conversion from gas logs back to solid wood
burning fuel.
FIGURE 1 ITEM PART DESCRIPTON PART NUMBER REMOVED
(1) Log Retainer IN-201
(1) ¼ by 20 by ½ Security Bolt PP-1225
(1) ¼ by 20 by ½ Security Bolt PP-1225
(2) Starter Air Intake Assembly IN-54
(2) ¼ by 20 by ½ Bolt HHCS PP-766
(2) ¼ by 20 by ½ Bolt HHCS PP-766
(3) Ash Grate IN-47
(4) Bottom Fire Brick #X1, 4 each PP-868
(4) Bottom Fire Brick #X2, 2 each IN-202
(4) Bottom Fire Brick #X3, 2 each IN-203
(4) Bottom Fire Brick #X4, 2 each IN-204
(5) Ash Pan Box IN-93
(5) Ash Pan Handle PP-1192
(6) Ash Pan Compartment Side Plate IN-72
(6) #8 by 32 by 3/8 TEK SMS, 4 each PP-159
(7) Gas Line Knock Out (left side) disposable
TABLE 1: INGLENOOK SOLID FUEL PARTS REMOVAL