Filter
Top Products
Version 1.0b
12
INSTALLATION, BURNERS
STEP 1:
Once TABLE 1 has been filled in, once all parts have been removed from the Inglenook Fireplace and
properly stored, then installation of the gas burner system can begin. FIGURE 5 shows the valve plate
assembly that is to be installed in the bottom of the Inglenook in the direction of the arrows. This assembly
includes the gas valve and gas line with front and rear gas orifices, the gas valve frame, the base plate, and
the pilot valve assembly. This assembly should be placed through the grate opening and should sit squarely
in the grate hole. If this assembly is not sitting square and flat in the grate recess, the rest of the burner
installation will not be possible or could be installed incorrectly.
FIGURE 5: BURNER INSTALLATION, STEP 1
FIGURE 6 shows the valve plate assembly installed in the bottom of the Inglenook Fireplace.
FIGURE 6: STEP 1 COMPLETE