Filter
Top Products
3-16
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 7.2
OL-29168-01
Chapter 3 Setting Up the Sensor
Changing Web Server Settings
–
TLS_DHE_DSS_WITH_AES_256_CBC_SHA
–
TLS_RSA_WITH_AES_256_CBC_SHA
–
TLS_ECDHE_RSA_WITH_AES_256_CBC_SHA
–
TLS_ECDH_RSA_WITH_AES_256_CBC_SHA
–
TLS_ECDHE_ECDSA_WITH_AES_256_CBC_SHA
–
TLS_ECDH_ECDSA_WITH_AES_256_CBC_SHA
–
TLS_ECDHE_RSA_WITH_3DES_EDE_CBC_SHA
–
TLS_ECDH_RSA_WITH_3DES_EDE_CBC_SHA
–
TLS_ECDHE_ECDSA_WITH_3DES_EDE_CBC_SHA
–
TLS_ECDH_ECDSA_WITH_3DES_EDE_CBC_SHA
–
TLS_DHE_RSA_WITH_3DES_EDE_CBC_SHA
–
TLS_DHE_DSS_WITH_3DES_EDE_CBC_SHA
–
TLS_RSA_WITH_3DES_EDE_CBC_SHA
–
TLS_DHE_RSA_WITH_AES_128_CBC_SHA256
–
TLS_DHE_DSS_WITH_AES_128_CBC_SHA256
–
TLS_DHE_RSA_WITH_AES_128_CBC_SHA
–
TLS_DHE_DSS_WITH_AES_128_CBC_SHA
–
TLS_RSA_WITH_AES_128_CBC_SHA
–
TLS_ECDHE_RSA_WITH_AES_128_CBC_SHA
–
TLS_ECDH_RSA_WITH_AES_128_CBC_SHA
–
TLS_ECDHE_ECDSA_WITH_AES_128_CBC_SHA
–
TLS_ECDH_ECDSA_WITH_AES_128_CBC_SHA
•
websession-inactivity-timeout seconds—Specifies the duration in seconds at which inactive web
sessions time out. The valid range is 600 to 3600 seconds. The default is 3600 seconds.
To change the web server settings, follow these steps:
Step 1
Log in to the sensor using an account with administrator privileges.
Step 2
Enter web server mode.
sensor# configure terminal
sensor(config)# service web-server
Step 3
Change the port number.
sensor(config-web)# port 8080
If you change the port number from the default of 443 to 8080, you receive this message:
Warning: The web server’s listening port number has changed from 443 to 8080. This change
will not take effect until the web server is re-started
Step 4
Enable TLS.
sensor(config-web)# enable-tls true