Filter
Top Products
SKU 65712 For technical questions, please call 1-800-444-3353. Page 19
ADJUSTMENT
Setting Remote Control Codes:
The Garage Door Opener’s Receiver and Remote Controls (75) transmitter are set 1.
to a matching code. If you purchase additional Remote Controls, the Garage Door
Opener must be programmed to accept the new Remote Control.
FIGURE Q
A B
.
(> 1 Second)
C D
.
2 X
2. Plug the Power Cord (9) into the nearest 120 volt, grounded, electrical outlet. The
Digital Display on the Housing (31) will ash with “H”, and the Light will illuminate.
The unit is in standby. (See Figure Q, Illustration A.)
Press and hold the “LEARN” Button for more than a second. The Digital Display 3.
will indicate “
.
”. (See Figure Q, Illustration B.)
Press the Key twice on the Remote Control (75) that you wish to operate the Ga-4.
rage Door Opener, and “
.
” will ash several times before “H” appears. Now the
Garage Door Opener has learned the code. (See Figure Q, Illustration C.)
NOTE: If you want the Garage Door Opener to learn additional remote codes, 5.
repeat the above steps. The Opener can learn up to six remote codes.
To erase all Remote Control (75) codes, press and hold the “LEARN” Button. The 6.
Digital Display will indicate “
.
” before indicating “H”. The codes are now erased
when the Digital Display ashes with “H”. (See Figure Q, Illustration D.)