Filter
Top Products
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
STOVE BODY ASSEMBLY
1. Lift off corrugated box enclosing
stove body crating.
2. Remove all screws fastening the wood
frame enclosure. Spread wood frame
open and lift away from plastic-
bagged stove body. The bottom pieces
of pallet wood will remain bolted to
the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see
Figure 6). Use an adjustable wrench
or a 10 mm socket. Remove six (6)
bolts and washers. Keep bolts and
washers to attach rear cover.
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom (If included)
(4) - Legs with leg leveler bolts
(1) - Bottom door
(3) - Top grates
(2) - Brackets
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to
attach bottom components to stove
body (see Figure 7). Rest stove on
drop cloth or blanket to avoid
scratching stove edges.
7. Remove remaining pallet wood
attached to bottom of stove body (see
Figure 7). Use an adjustable wrench to
remove bolts.
8. Fasten each leg to stove with four (4)
M8 x 1.25 - 20 mm bolts. Use a flat
washer and lock washer with each
bolt. Tighten bolts into threaded holes
on stove body (see Figure 8 and
Figure 9). Return stove to upright
position.
BOLT
BACK STOVE
PANEL
FIGURE 6 - REMOVING BACK PANEL
FIGURE 7 - LAYING DOWN STOVE ON SIDE
TOP OF
STOVE
UNIT
FRONT OF
STOVE UNIT
REMOVE PALLET
BOLTED TO
STOVE BOTTOM
BOTTOM OF
STOVE UNIT
LEG
HOLE
LEG
HOLE
DOOR CATCH BOLT
WITH ADJUSTABLE
HEX NUTS HOLE
FRONT
DOOR HINGE STEP
BOLT HOLE
LEG
HOLE
LEG
HOLE
FIGURE 8 - LOCATING THREADED HOLES FOR STOVE BOTTOM, LEGS
DROP
CLOTH/
BLANKET
4