New Buck Corporation CDVB200 Stove User Manual


 
SERVICE HINTS
When Gas Pressure Is Too Low
Pilot will not stay lit
Burners will have delayed
ignition
Heater will not produce specified
heat
When Gas Quality Is Bad
Pilot will not stay lit
Burners will produce flames and
soot
Heater will backfire when lit
You may feel your gas pressure is too
low or gas quality is bad. If so,
contact your local gas supplier.
REPLACEMENT
PARTS
NOTE: Use only original replacement
parts. This will protect your warranty
coverage for parts replaced under
warranty.
ACCESSORIES
Purchase these heater accessories from
your local dealer. If they can not sup-
ply these accessories, call our Parts
Department at 1-828-765-6144 for re-
ferral information. You can also write
to the address listed on the back page
of this manual.
RECEIVER AND HAND-HELD
REMOTE CONTROL KIT
PART# PO FDC-504
For remote-ready models. Allows the
gas log heater to be turned on and off
by using a hand-held remote control.
WALL THERMOSTAT
PART# PE 400142
The desired comfort setting can be se-
lected on the wall thermostat and the
log heater will automatically cycle
from pilot to the heat setting selected.
SERVICING
Repair and replacement work should only be performed by a qualified service technician.
Always shut off the gas supply and make sure heater is cool before beginning any service
operation. Check for gas leaks after servicing.
REPAIR PARTS
A parts list with exploded view follows. Always include correct name, part number, and model
number of the heater when ordering service parts. Please contact your local dealer or distributor
when ordering . If one is not available, you may contact.
New Buck Corporation
8000 Highway 226 South
Spruce Pine, NC 28777
24