Brother PE-600II Sewing Machine User Manual


 
Using the Optional Cap Frame 175
7
2
Tighten the two screws.
Make sure that the stopper is firmly secured.
Attach the mounting jig to a stable mounting
surface, such as a desk.
3
Loosen the thumb screw for the mounting jig
to open the mounting bracket so that it is
wider than the thickness of the mounting
plate.
The mounting bracket can be mounted onto
a plate with a thickness from 9 mm (3/8
inch) to 38 mm (1-1/2 inches).
4
Securely clamp the mounting bracket onto the
mounting surface by tightening the thumb
screw.
1 Mounting bracket
2 Mounting surface
3 Tighten thumb screw
5
Check that there is no looseness.
If there is looseness, mount the mounting jig
onto the mounting surface again.
Note
Be sure that the mounting bracket is
securely clamped onto the mounting
surface and that the thumb screw is firmly
tightened.
Do not attach the mounting jig to an
unstable surface (flexible, bent or warped).
Be careful that the mounting jig does not fall
when it is removed.
6
Adjust the size of the mounting jig according
to the type of cap being embroidered.
1 Low Profile (Low fitting)
2 Standard (Pro style)
Note
Either the standard type cap frame or the
advanced type cap frame can be used in the
standard position. Only the advanced cap
frame can be used in the low profile
position.
1
2
3
2
1
Sapphire_chapt7.fm Page 175 Friday, November 18, 2005 12:10 PM