Filter
Top Products
MIC612 Thermal Camera On-Screen Display (OSD) Menus (Pelco Protocol) | en 53
Bosch Security Systems, Inc. Installation Manual F.01U.249.416 | 2.0 | 2012.09
7 On-Screen Display (OSD) Menus (Pelco Protocol)
This chapter identifies and describes each OSD menu option, as well as the default setting for
each option, for Pelco protocol. For step-by-step instructions, see Section 9 Common User
Commands, page 59 and Section 10 Advanced Features, page 62.
To open the main Setup Menu in Pelco protocol: Press 95-PRESET for approximately 2
seconds. The screen Setup Menu appears.
Setup Menu Choices:
Setup Menu
Exit...
Command Lock: OFF
Bosch Menu
Camera Setup
PTZ Setup
Edit Password
*FastAddress: Not Set
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
* = Factory Setting
Focus / Iris: Select
Menu Description
Exit Exits the menu.
Command Lock Allows or prohibits accessing locked commands. (If password is set,
you are prompted to enter the password. The default setting is ON.
Bosch Menu Accesses the full MIC612 configuration menu and all MIC612
settings.
Camera Setup Accesses adjustable camera settings such as White Balance and
Night Mode.
PTZ Setup Accesses adjustable pan/tilt/zoom (PTZ) settings such as tours, scan
speed, edit presets, limit stops, recording, and AutoPivot settings.
Edit Password Changes the password.
FastAddress Sets or changes a camera address.
Advanced
Software Version Displays the current software versions.
Ack and Reset Alarms Acknowledges and resets active alarms.
Restore All Settings Restores all settings to their original default setting.
Reset All Memory Clears all settings, including scene shots, tours, and recordings
stored in the MIC612 memory.
NOTICE!
If commands are locked and you press Focus or Iris, the camera displays the on-screen
message: “Command is Locked.”