Filter
Top Products
MIC612 Thermal Camera Installation | en 29
Bosch Security Systems, Inc. Installation Manual F.01U.249.416 | 2.0 | 2012.09
5. Locate the Brown and Grey wires from the composite cable.
6. Connect the heater wires Brown and Grey to terminal block HD6 as labelled on the PCB.
The heaters are thermostatically controlled and will automatically turn on at +5 °C (+41
°F) and turn off at +15 °C (+59 °F).
7. Check all connections.
8. Close the PSU enclosure.
9. Reconnect the power supply to the power source.
4.5 Fitting the Optional Sunshield (MIC612)
The MIC612 Sunshield is designed to provide additional protection against direct solar
radiation. It is a two-part moulding and comes supplied with eight (8) stainless steel bosses
and eight (8) M3 washers and retaining screws. To fit the sunshield, follow these steps:
1. Turn on the power to the camera so that you can rotate the camera head up to fit the
bottom half of the sunshield (see step 8).
2. Rotate the camera under power--do not rotate by hand--until the bottom of the camera
head is facing up.
3. Remove the four (4) retaining bolts from the lid of the camera.
4. Place a stainless steel boss into each screw hole and tighten using a flat head
screwdriver.
5. When all four (4) bosses have been fitted, align the holes in the sunshield with the
correponding bosses. Push the sunshield until it fits snugly onto the camera head.
6. Fix the sunshield to the bosses using the M3 stainless steel washers and screws.
7. Rotate the camera under power--do not rotate by hand--until the top of the camera head
is facing up.
8. Repeat steps two through six on the top lid of the camera. When fitted properly, both
halves of the sunshield should align and meet at the back of the camera head.
Figure 4.11 Graphical depiction of sunshield assembly
CAUTION!
DO NOT REMOVE the lid from the camera, and do not back drive the pan or tilt axis manually.
Doing so will void the warranty. Back driving may also strip teeth off the internal gears.
Number Description
1 Spacer/Stud, 316 SS
2Sunshield
3 M3 x 10 mm screw, 316 stainless steel (SS),
Pozidriv with pan head
4 M3 washer, 316 stainless steel (SS)