Filter
Top Products
Camera interfaces
Hardware Installation Guide V2.0.0
40
Camera I/O pin assignment (8 pin) (GUPPY)
The 8-pin camera I/O connector (only Guppy cameras) is designed for indus-
trial use.
It provides:
• access to the inputs and outputs on the camera
• a serial interface
Note
L
The part number of the appropriate straight I/O connector is:
• HIROSE HR25-7TP-8S, AVT article number K7600503
AVT also supplies various I/O cables of different lengths, a
selection is listed below:
I/O cable, open 8-pin HIROSE female to open end, 2.0 m E1000842
I/O cable, open 8-pin HIROSE female to open end, 5 m E1000843
The following diagram shows the pinning of the I/O connec-
tors as viewed in pin direction.
Figure 16: Camera I/O connector pin assignment (GUPPY)
1
3
4
6
7
8
5
2
Pin Signal Direction Level Description
1 CameraOut1 Out TTL Camera Output 1
2 CameraOut2 Out TTL Camera Output 2
3 CameraOut3 Out TTL Camera Output 3
4 CameraIn In TTL Camera Input
5 RxD_RS232 In RS232 Terminal Receive Data
6 TxD_RS232 Out RS232 Terminal Transmit Data
7 ExtPower +8…36V Power Supply
8GND GND Ground