Filter
Top Products
Safety instructions
Hardware Installation Guide V2.0.0
18
Safety instructions for board level cameras
Note
L
Read the Guppy Technical Manual and this safety instruc-
tions before use.
Abuse or misapplication of the camera may result in lim-
ited warranty or cancelation of warranty.
Caution-ESD Board level cameras: ESD warnings
•Only qualified personnel is allowed to install and oper-
ate the Board level cameras.
• Board level camerass are delivered without housing.
Handle the sensor board and main board with care. Do
not bend the boards. Do not touch the components or
contacts on a board. Hold a board by its edges.
• Sensor board and main board are sensitive to electro-
static discharge. To avoid possible damage, handle all
static-sensitive boards and components in a static-safe
work area. Follow the procedures below.
• ESD (electrostatic discharge): Static electricity can
damage the sensor board or the main board of your
Board level cameras. To prevent static damage, dis-
charge static electricity from your body before you
touch any of your Board level cameras’s electronic com-
ponents, such as sensor board or main board. To do so,
use a static-safe work area with static-dissipative mat
and wear a static-dissipative wrist strap. Do not hold
any components of your Board level cameras against
your clothing. Even if you are wearing a wrist strap,
your body is grounded but your clothes are not.
• Do not remove the sensor board and main board from its
anti-static packaging unless your body is grounded.
• ESD shielding: To protect the boards from radiation of
other modules or devices use a special ESD protective
housing.