Filter
Top Products
PHASE RESEARCH
USER GUIDE
SECTION 13 - PARAMETERS PROGRAMMING 13-15
9. Press or to select the desired daypart.
10. Press to move the cursor to BEEP.
11. Press to move the cursor to [=] immediately to the right of BEEP ON
ARRIVAL.
12. Press or to toggle the BEEP ON ARRIVAL option to YES or
NO.
13. Press to select the grade (A, B, C, etc.) for which you wish to set or
change the target time. (If you do not want targeting for a particular grade, set
the grade’s target time to 0.)
NOTE: The target time for B must be equal to or greater than that for A; the target
time for C must be equal to or greater than that for B, and the same applies
through the entire sequence of letter grades. The Timer adjusts automatically
to ensure this.
Pass/Fail grading may be used rather than letter grading: Set all letter grades
except F to the same time – the maximum time allotted to the event (MENU,
GREET, etc.) to achieve a passing grade. For example, if you want to make
10 seconds the (Pass) time, set A, B, C, and D to a time of 10 (the selected
event must occur within this amount of time in order to “pass.”).
14. Press to move the cursor immediately to the left of the B (beep) column
field.
15. Press or to set the beep count for the grade you have chosen
(0 - 9 beeps may be chosen). The Remote will beep (the number of times spec-
ified) when the selected event exceeds the target time you have selected.
16. Press to move the cursor immediately to the left of the P (print) column
field.
17. Press or to toggle the printing option for the grade to Y (yes) or
N (no). If you select Y (yes), the Timer will print every car that falls within the
particular grade’s target time.