Filter
Top Products
PHASE RESEARCH
USER GUIDE
SECTION 13 - PARAMETERS PROGRAMMING 13-13
7. Press to change the time in 15-minute increments. The Timer
adjusts automatically to prevent time gaps or overlaps.
NOTE: The ending time of each shift coincides with the starting time of the next shift
for the same day, though you may use different shifts for each day of the week.
Shift 1 always starts at the opening time for the day, and the last programmed
shift always ends at the closing time for the day.
8. Press to add a new shift by moving the cursor immediately to
the right of the first unused shift number (for which START and STOP times
have not yet been entered).
9. Press or to add the shift. The START and STOP times are now
entered.
10. Press to delete shifts by moving the cursor to the
[=] field of the first shift – in order from top (1) to bottom (4) – you wish to
remove.
11. Press to delete the shift. Any shifts that follow will automatically be
removed as well. And the store’s closing time will automatically be entered in
place of the STOP time for the last remaining shift.
NOTE: If all days use the same shifts, you can set the shifts for only one day and then
use the COPY TO feature to copy the same settings to all other days, as
explained in the following steps.
12. Press to move the cursor immediately to the right of DAY:.
13. Press or to select the desired day from which to copy.
14. Press to move cursor to COPY.
15. Press to move the cursor to <ENTER>.
16. Press to copy the displayed shift settings to all other days, replacing
any individual shifts previously set for these days.