A SERVICE OF

logo

10.8 Administrator Settings
10
10-59
Utility Mode Operations Chapter 10
Setting the Administrator Code Change Function
This function is used to change the administrator code.
1 Press the [Utility] key.
2 Touch [Admin. Mode].
3 Using the keypad, type in the administrator code.
Touch [Enter].
4 Touch [Admin. Set.].
5 Touch [3/4].
6 Touch [Administrator
Code Change].
7 Use the keypad to type
in the currently
specified administrator
code, and then touch
[Enter].
If [Cancel] is
touched, the
administrator code
is not changed. The
screen shown in
step 6 appears
again.