Populating the Library with Data Cartridges
For information on working with the cartridge magazines, see “Cartridge
Magazines” on page 4-30.
1. Unlock the cartridge magazines.
v Using the Operator Control Panel: Control → Magazines
v Using the Web User Interface: Manage Library → Release Magazine
Note:
The magazines will relock after 15 seconds if they have not been
removed.
2. Remove all magazines from the library.
3. Insert cartridges in the left magazine(s). Do not store cartridges in the I/O
Station or in the dedicated cleaning cartridge slot. See “2U Library I/O Slot,
Storage Slots and Drive Slot Element Addresses and Physical Locations” on
page A-1 or “4U Library I/O Slots, Storage Slots, and Drive Slots Element
Addresses and Physical Locations” on page A-2 for determining slot location.
4. Insert cartridges in the right magazine(s).
5. Put all magazines back into the library. The library will automatically start up
and perform an inventory check.
a77ug185
1
Figure 4-39. Finger Holes on back side of 4U library I/O Station
Chapter 4. Installation and Configuration 4-33
