system is serviced by DHCP (Dynamic Host Configuration Protocol) server, the
network parameters will be automatically set. Once remote access has been
established, you can complete the configuration of your library.
1. Access the Configure menu using the Operator Control Panel.
a. From the screen that shows the library logo (Home screen), press either the
UP or DOWN button to get to the Main Menu.
b. Press the DOWN button to select Configure.
c. Press the ENTER button to display the Configure menu.
2. Press the DOWN button to highlight the Network menu.
3. Press the SELECT button to display the Network screen.
4. Select IP STACK to change Internet Protocols. Choose IPv4 only, IPv6 only, or
IPv4 & IPv6.
5. If you do not want to select DHCP as your library network setting, skip this
step and proceed to the next step. If you want to select DHCP as your library
network setting, complete the following steps:
a. Press the SELECT button to highlight the DHCP field.
b. Press the DOWN button to select ON.
c. Press the SELECT button to apply your selection.
d. Skip to Step 7.
6. Press the DOWN button to select IP Address.
a. Press the SELECT button to highlight the IP Address field.
b. Press the UP or DOWN button to select the digit(s) of your library’s IP
Address.
c. Press the SELECT button to highlight the next digit(s) in your IP Address.
d. After entering the final digits, press the SELECT button to apply your
entries.
7. Press the DOWN button to select Netmask.
a. Press the SELECT button to highlight the Netmask field.
b. Press the UP or DOWN button to select the digit(s) in your library’s
Netmask address.
c. Press the SELECT button to highlight the next digit(s) in your library’s
Netmask address.
d. After entering the final digit(s) in your Netmask address, press the
SELECT button to apply your entries.
8. Press the DOWN button to select Gateway.
a. Press the SELECT button to highlight the Gateway field.
b. Press the UP or DOWN button to select the digit(s) in your library’s
Gateway address.
c. Press the SELECT button to apply your entries.
9. Press the DOWN button to select Ethernet.
a. Press the DOWN button to highlight the Ethernet field.
b. Press the SELECT button to change the Ethernet setting.
c. Press the DOWN button to select a new setting.
d. Press the SELECT button to apply the new setting.
e. Press the DOWN button and select one of the following:
v Save - to apply your new configuration.
v Cancel - to cancel all of your entries and leave the settings as they were.
4-16 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
