Note: The gray markers show where conductive tape should be placed.
j. Push the black tab back underneath the drive sled. When inserted properly,
only the handle of the tab will be visible.
2.
Power ON the replacement library enclosure.
a. If power ON is successful:
1) After power up, the Ready/Activity LED (1 in Figure 10-17 on page
10-17) will turn ON.
2) Proceed to “Swapping Cartridge Magazines.”
b.
If power ON is not successful:
1) The Error LED (4 in Figure 10-17 on page 10-17) will turn ON.
2) Power OFF the replacement library enclosure.
3) Contact Technical Support for further instructions.
Swapping Cartridge Magazines
1. Manually release and remove all magazines from the defective library and from
the replacement library enclosure. To release and remove a cartridge magazine:
a. Find the access holes for the right and left magazines (see Figure 10-20 on
page 10-20 and Figure 10-21 on page 10-21).
2U Library 4U Library
a77ug203
Figure 10-19. Drive sled taping diagrams
Chapter 10. Check, Adjust, Remove, and Replace 10-19
