Filter
Top Products
Installation Instructions
Continued
12. Install window rail seal and window lock
bracket and drain cup. Press foam meeting
rail seal into place and cut to proper length.
Make a mark and drill a pilot hole 2.4 mm
(3/~~), then install lock bracket using a wood
screw. Seal small openings around installa-
tion with gum-type sealer.
NOTE: Window lock bracket must be installed
at all times to be sure air conditioner does not
fall out of window. Remove only when you
wish to remove air conditioner from window.
13. Install plastic drain-cup spout into hole at
rear of cabinet. Spout should be facing
downward through hole.
OPTIONAL: During high humidity, condensate
may drip from the outside of your air conditioner
onto the ground below. If your air conditioner is
installed where this is undesirable, you can direct
the water to a more suitable spot by simply
attaching a 15.9 mm (78”) inside-diameter, thin-
walled hose to the drain spout at rear of cabinet.
14. Insert air conditioner into cabinet. Slide
unit all the way into the cabinet. Do not push
against sharp fins and plastic parts.
Attach green ground wire to the left-front
corner of unit base by using ground wire
screw.
Electrical Shock Hazard
Attach the ground wire to the cabinet
during installation.
Failure to do so can result in death or
electrical shock.
15. Attach front panel by placing bottom edge
on clips and pushing top down, then in
and up.
16