Filter
Top Products
Installation Instructions
Continued
b
Measure distance from inside one
window channel to lnslde of the
other and subtract 6.4 mm (W)
*
I
Lefl
filler
board
0
L Front A
6. Attach side mounting angles to the sides of
the cabinet by using 4 hex-head sheet metal
screws. Punch holes in seal strip before
driving screws. Be sure flange of each side
mounting angle faces inside. Now attach top
mounting angle to cabinet by using 3 hex-
head sheet metal screws. Again, be sure
flange is facing inside.
7. Measure and cut filler board to proper sizes.
First, measure the distance from inside one
window channel to the inside of the other
channel and subtract 6.4 mm (W). Now
subtract the width of the air conditioner and
divide by 2. This will give you the width to cut
each filler board. Be sure to cut the filler board
across the mid-section of its longest measure-
ment. Because the filler boards will be equal in
width, they will automatically center your air
conditioner in the window.
f
6. Apply seal strips and attach filler boards.
Determine which will be your left and right filler
boards. The holes on each board should align
with the holes in the side mounting angles.
Each filler board should also extend about
1.3 cm (X1’) above the top edge of the air
conditioner cabinet. Now apply 9.5 mm
@“)-wide seal strips on the room side of each
filler board along the bottom and window
channel edges. Now attach the filler boards to
the side mounting angles with 4 round-head
sheet metal screws. Tighten the screws only
loosely, so the filler boards can be moved
back and forth.
9. Insert side mounting slides all the way into
the top mounting channel.
14