Filter
Top Products
-head
ow lock
bracket
6. Pull out sliding curtains while holding air
conditioner in window. Extend curtains on
both sides until they reach the insides of the
window channels. (Pulling curtains slightly
inward allows for easier sliding.)
Mark and drill a pilot hole (2.4 mm [Yx”]) in
each curtain handle before installing round-
head screws.
NOTE: If space is a problem, use the pre-
drilled holes in the top flanges of the curtains
for the round-head screws.
7. Install window rail seal and window lock
bracket. Press foam window rail seal into
place and cut to proper length. Mark and drill a
pilot hole (2.4 mm [3/~“j), then install window
lock bracket using the round-head screw. Seal
small openings around installation with gum-
type sealer.
NOTE: Keep window lock bracket installed at
all times to ensure that unit will not fall out of
the window. Remove window lock bracket only
when you wish to remove air conditioner from
window.
8. Attach front panel by placing bottom edge on
clips and pushing top down, then up and in.
11