Filter
Top Products
20
Step 10
Secure frame assembly to anchored base
You will need: completed frame assembly, four 1/4-20 x 1
1/2 inch bolts, eight nylon washers, four 1/4-20 hex nuts,
four plastic buttons and a 7/16 inch wrench.
ƽCAUTION: The base must be anchored at all four
anchor points prior to mounting the frame to the
base. See base installation instructions.
Set the assembled frame onto the base. Align the holes
of the frame assembly with the holes in the base. Slip a
washer on a 1/4-20 x 1 1/2 inch bolt. Insert the bolt
through the frame and the base assembly, add a washer
and a 1/4-20 hex nut. Figure 11 (a). Install the remaining
bolts. Tighten using a 7/16 inch wrench.
Align the holes in the flanges of the base assembly with
the front and back frame connector holes. Push in the
four plastic buttons. Figure 11 (b).
Figure 11
(a)(b)
Step 11
Install left end panel
You will need: frame assembly and left end panel
(Number 1).
Place the bottom of the left end panel on the upright
frame lower cross piece. Set the end panel upright in
place. Figure 12.
Figure 12
Step 12
Install three back panels
You will need: frame assembly and the three back panels
(Number 2).
Place the bottom of one back panel on the back frame
connector, notches to the top. Set in place to the far right,
butting up against the right upright frame. Figure 13.
Figure 13