Filter
Top Products
10
Method 3
A 3/8 inch machine screw anchor, using a
3/8-16 x 1 1/2 inch machine screw and a flat washer.
Figure 8.
Note - Use a 3/4 inch diameter concrete drill bit for drilling
the hole for the screw base. The machine screw anchor
requires a setting tool.
3/8-16 x 1 1/2 machine screw
3/8 inch flat washer
Mount plate
3/8 inch screw anchor
Drilled hole
Figure 8
Method 2
A concrete lag bolt, a minimum of 3/8 inch x 2 1/2 inches
long with a 3/8 inch diameter long lag shield and a
3/8 inch flat washer. Figure 7.
Note - Use a 5/8 inch concrete drill bit for drilling the hole
for the lag shield.
Concrete lag bolt
3/8 inch flat washer
Mount plate
Lag shield
Drilled hole
Figure 7
Typical base installation for a wood deck
After assembling the base according to the assembly
instructions, position the base assembly on your deck for
anchoring.
ƽCAUTION: Combustible materials should never be
within 24 inches of the top, bottom, back or sides of
the barbecue. Do not locate under overhead
combustible construction.
Note - With the lid open, the depth of the barbecue is 28
inches, front to back. After positioning, level the base.
(See Step "Level the base.")
After leveling, anchor the base to the deck. We
recommend using a minimum of a 3/8 inch x 1 1/2 inch
lag bolt with a 3/8 inch flat washer. Figure 9.
Note - Use a 3/16 inch drill bit for drilling a pilot hole for a
3/8 inch lag bolt.
ƽWARNING: The base must be bolted down
(anchored) at ALL four anchoring points prior to
barbecue assembly.
3/8 inch x 1 1/2 inch lag bolt
3/8 inch flat washer
Mount plate
Drilled hole
Figure 9