Filter
Top Products
❉
Programming HomeLink
®
System to the Torquemaster
®
idrive
®
(Primary)
Programming/Training HomeLink
®
Unit
GARAGE DOOR MAY OPERATE DURING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INJURY, PLACE THE EMERGENCY
DISCONNECT HANDLE IN THE MANUAL OPERATED POSITION.
1. Pull the manual disconnect to put the opener in the disengaged
position.
2. Verify the HomeLink
®
unit has an empty channel – press the
desired HomeLink
®
button and observe the LED – if it flashes
slowly, the channel is empty and ready for programming. If
pressing the desired channel/button causes the LED to blink
rapidly, or come on without blinking this channel is already
programmed. You either need to choose a different channel/
button on the HomeLink
®
, or perform Step 3 below.
3. OPTIONAL – To completely clear all channels on the HomeLink
®
unit, press and hold the two outside buttons on the HomeLink
®
unit until the HomeLink
®
LED light begins to flash rapidly
(approx. 20 seconds), then release both buttons. (Do not perform
this step to train additional hand-held transmitters.) NOTE: This
operation erases all previously learned transmitters and you will
need to re-teach any other transmitters to your HomeLink
®
unit.
4. Hold the end of the Wayne
Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink
®
surface –
keeping the HomeLink
®
indicator light in view.
5. Simultaneously press and hold the Wayne Dalton transmitter
large button and desired button on the HomeLink
®
module,
continue to hold both buttons. In less than 10 seconds the LED
on the HomeLink
®
module will either go solid or give a single
quick flash, release both buttons when either occur.
NOTE: If this procedure is unsuccessful, perform Alternate procedure
on next page.
Teaching HomeLink
®
to the idrive
®
opener
6. Press and release the red program button on the idrive
®
opener.
The idrive
®
unit will beep once, indicating that it is ready to learn.
NOTE: The idrive
®
will remain in the learn mode for 30 seconds.
7. Press the HomeLink
®
button used in Step 5 above for 1 to 3
seconds. The idrive
®
will beep indicating a successful learn.
8. Return the manual disconnect to the engaged position.
9. Press the HomeLink
®
button once more to operate the door.
NOTE: The first transmitter command after programming will only move
the door through a six inch up/down cycle. Normal door operations will
occur on the second use of the transmitter.
NOTE: This step can only be done on automobiles equipped with the
HomeLink
®
system.
NOTE: Programming HomeLink
®
requires a Wayne-Dalton Transmitter
that is programmed to the opener (the wallstation and transmitter(s)
supplied with the opener, come pre-programmed from the factory). Any
additional wallstation(s) or transmitter(s) will need to be programmed to
the opener, see page 40.
IMPORTANT! Use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
®
unit does not
learn the transmitter, when using the vehicle’s instructions.
NOTE: If Primary programming does not work then use the Alternate
procedure on next page.
NOTE: Vehicle may need to be in accessory position when
programming. Check car owner’s manual.
NOTE: HomeLink
®
is a registered trademark of Johnson Controls.
WARNING
35
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com