Filter
Top Products
II
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
PRE-INSTALLATION INSPECTION OF YOUR GARAGE DOOR
PRIOR TO TORQUEMASTER
®
IDRIVE
®
INSTALLATION
Congratulations, you have just purchased one of the world’s safest garage door openers! By
design, this opener will detect obstructions and reverse rather than force the door through
obstructions.
To ensure your new idrive
®
opener works as intended, your garage door must be
installed and balanced properly.
WHEN INSTALLING A NEW DOOR WITH AN IDRIVE
®
:
If you just nished installing a new garage door along with an idrive
®
opener, then proceed with
these instructions beginning with Step 14 on page 21. If you were referred to these instructions
as part of a new door installation, then proceed with these instructions beginning with Step 1
on page 7.
WHEN INSTALLING AN IDRIVE
®
ON AN EXISTING DOOR WITH TORQUEMASTER
®
OR
TORQUEMASTER
®
PLUS:
Before installing the idrive
®
opener, open and close you door manually to ensure that it
operates smoothly from top to bottom. A properly balanced door should not take a lot of effort
to open or close by hand. The door should stay in the open and in the closed position without
drifting down or creeping up. If a door opens fast going up, the door may need spring tension
reduced. If the door drops fast going down, the door may need spring tension increased.
If the operation of the door does not meet these criteria, you need to adjust the spring balance
per your door’s Installation Instructions and Owner’s Manual or call a professional installer to
make adjustments before installing idrive
®
.
If the door operates properly, check and record your Torquemaster
®
counterbalance spring
settings (for Torquemaster Plus spring settings, see warning tag(s) attached to the end
brackets or refer to your door Installation Instructions and Owner’s manual). Then proceed
with unwinding of the spring(s) for installation of your idrive
®
, carefully following the
instructions in the appropriate STEP R1 of your idrive
®
Installation Instructions and Owner’s
Manual. After the idrive
®
is installed on the Torquemaster
®
tube, rewind the Torquemaster
®
or
Torquemaster
®
Plus to the previously recorded settings.
Instruction manuals are available for download on www.wayne-dalton.com. Use the web site
to also nd the location of your nearest professional dealer.
Check out the new idrive
®
installation video at www.wayne-dalton.com
Idrive
®
for Torquemaster
®
http://www.wayne-dalton.com/idrive_TorqueMaster.asp
Look for this symbol.
®