Filter
Top Products
10
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
Loose
Winding
Shaft
Cable
Drum
Left Hand Side
Single Spring Application
Groove
Flagangle
Torsion
Tube
NOTE: If you just installed the
Torquemaster
®
Plus
counterbalance,
continue with Step 4 on page 12. If you
have the Torquemaster
®
counterbalance
system, complete Steps 2-3 on pages 10
and 11.
Shake the torque tube gently to extend the
winding shafts out about 5" on each side.
For single spring applications, there will be
no left hand spring in the torque tube.
Lift the torque tube and rest it on the top of
the flagangles. Orient torque tube so that
back of opener is flat against header/
mounting surface.
NOTE: Cable drums and torque tube are
cam shaped to fit together only one way.
Pre-wrap the Torquemaster
®
cable drum
with the counter balance cable 1/2 wrap
(see illustrations).
To install the cable drum, slide the cable
drum over the winding shaft until the cable
drum seats against the torque tube. The
winding shaft must extend past the cable
drum far enough to expose the splines and
the groove.
Align the winding shaft groove with
the round notch in the flagangle.
Repeat for opposite side for double spring
applications.
For single spring applications, insert
the loose winding shaft into the left hand
cable drum prior to sliding the cable drum
over the torque tube.
NOTE: On single spring applications, take
care in handling the loose winding shaft
(left side) so that it does not slide back into
the torque tube.
Beginning with the right hand side, lubricate
entire circumference of the drive gear
with lubricating oil. Slide the drive gear onto
the winding shaft splines until it touches
the flagangle.
NOTE: On single spring applications,
no drive gear is required on the left side.
NOTE: If additional lubricating oil is
required “Dura-Lube Engine Oil Treatment”
is recommended.
Cable Drum/ Drive Gear
Installation
Torque
Tube
Winding
Shaft
Cable Drum
Counterbalance
Cable
Torque
Tube
Cable Drum
Round
Notch
Winding
Shaft Groove
Winding
Shaft Splines
Lubricating
Oil
Drive
Gear
Flagangle
Drive
Gear
Winding
Shaft
Cable
Drum
Cable
Drum
Splines
Groove
Flag Angle
Round
Notch
2
TorqueMaster
®
Installation
Tools Needed:
Step Ladder
1/2 Wrap Shown
Winding
Shaft Groove
align and seated
in ro
IDRIVE
®
FOR TORQUEMASTER
®
INSTALLATION