6 BAS-SVP10A-EN
Overview
Related Documents
See the following documents for Communicating Thermostat installation and configuration
information.
• Trane Communicating Thermostats for Heat Pump Control User Guide (BAS-SVU10x-EN)
• Trane Communicating Thermostats for Rooftop Control User Guide (BAS-SVU11x-EN)
• Trane Communicating Thermostats for Fan Coil Control User Guide (BAS-SVU12x-EN)
See the following documents for Tracer SC network integration information.
• Tracer™ SC System Controller Installation and Setup (BAS-SVX31x-EN)
• Tracer™ BACnet™ Terminator Installation (X39641151-01x)
• Unit Controller Wiring Guide For the Tracer SC™ System Controller (BAS-SVN03x-EN
Finally, see the following documents for information about equipment including fan coils, rooftop
units, and heat pumps.
• Communicating Thermostats for Rooftop and Heat Pump Control Product Data Sheet
(BAS-PRC064-EN)
• Communicating Thermostats for Fan Coil Control Product Data Sheet
(BAS-PRC065-EN)
All these documents are available from your Trane distributor.
Planning Your Integration
Study the following information presented in the chapters of this guide as you plan the work:
• Communicating Thermostat BACnet objects (points) and their properties (ranges, values, and
enumeration sets for points). (See
“Summary of BACnet Objects,” p. 7. and “BACnet Object
Properties,” p. 14.)
• Tips and considerations presented in “Additional Information and Considerations,” p. 29.If
your network is managed by a Tracer SC, pay special attention to “Tracer SC Network
Configuration,” p. 32.
• Wiring instructions in “Wiring Requirements for Communicating Thermostats,” p. 25.
• Available Graphical User Interface (GUI) objects that you can use in graphics presented in
“Objects You Can Use in Site Graphics,” p. 23.
“How To” Information
The following “how to” questions are described or clarified either in this manual or in other
documents cited in this table.
Question Information Location or Answer
How do I set up alarming in Tracer SC?
See the Tracer™ SC System Controller Installation and
Setup Manual (BAS-SVX31x-EN)
How do I set the MAC address of the Trane Communicating
Thermostat?
See “Default Device Name and Default Device ID,” p. 7.
Also, see the appropriate User Guide listed in “Related
Documents” on this page.
How do I install a Trane Communicating Thermostat on the
Tracer SC link?
See “No automatic installation,” p. 32.