Filter
Top Products
38 GETTING STARTED WITH THE CBR 2™ SONIC MOTION DETECTOR © 1997, 2004, 2006 TEXAS INSTRUMENTS INCORPORATED
Using a CBR 2™ Sonic Motion Detector with a CBL 2™
System or with CBL 2™ System Programs
Using a CBR 2™ sonic motion detector as a conventional motion detector with a
CBL 2™ System
The CBR™ motion detector can be used as a conventional motion detector with the Texas
Instruments
CBL 2é (Calculator-Based Laboratoryé) system.
A special cable is required to connect
the CBR 2™ motion detector to a
CBL 2™ system.
You may order the cable by calling
1-800-TI-CARES.
Do not connect a
CBR 2™ motion detector to a CBL 2™ system at the same time that the
CBR 2™ motion detector is connected to a calculator. The calculator must be connected to
the
CBL 2™ system.
You may need to change the
CBL 2™ system program as noted below.
Collecting Motion Data Using the CBR 2™ sonic motion detector with a CBL 2™ System
Ê Insert batteries into the CBL 2™.
Ë Connect the CBL 2™ motion detector to a TI graphing calculator using the I/O unit-to-
unit link cable.
Ì Plug your CBR 2™ motion detector into the DIG/SONIC port of
the
CBL 2™ system using a CBL-to-CBR cable (sold separately).
Í Run DataMate from the Apps menu on the TI-83 Plus or
TI-84 Plus family of products, the TI-89, TI-89 Titanium,
TI-92 Plus, or Voyageé 200.
TI83/84 Family
TI89/Titanium/92+/V200