Filter
Top Products
7/50D Plus or 7/50D Controller Chapter 3: Installation 52
The System Setup screen appears:
The current passwords are displayed under Operator Password and Setup
Password. A value of 0000 means that no password is required.
2. Touch Operator Password or Setup Password, as appropriate.
A keypad pops up, with an entry of 0.
3. Enter up to four digits. If you want to remove the password protection, simply leave
the entry at 0. Use ← to erase any mistakes. Use ↵ to enter the value.
The keypad disappears and the new setting appears under Operator (or Setup)
Password. In addition, if you have added a password, a new button appears on the
screen, labeled Log Off Operator and/or …Setup, depending which
passwords are now active.
Note: When entering a password, all four digits must be supplied. For
example, if you enter a password of 2 here, you will need to enter
0002 when the controller prompts for the password.
If desired, you can also change the duration for which a password remains effective. During
operation, the password-protected screens are available either until the user logs off or until
this time elapses, whichever comes first. This feature prevents the password from remaining
active if a user forgets to log off.
Note: The password timer starts when the user logs on. It expires even if the
user is actively using the screens when the chosen time is up. If the
timer expires, the system goes to the Station Summary screen. Your
password duration should be long enough to allow authorized users to
complete their tasks but short enough to provide adequate protection
against tampering.