Filter
Top Products
7/50D Plus or 7/50D Controller Chapter 3: Installation 49
Copying Settings from One Pump to Others
If other pumps at your facility will use the same settings as a pump you have already set up,
you can copy the settings from this pump to the others. To do so:
1. At the Pump n Setup screen (for the pump you want to copy from), touch Copy in
the screen’s upper right.
The Pump Copy screen appears, showing the pump number for the pump you are
copying from:
2. Follow the directions below to copy settings to one other pump, a range of pumps, or
all pumps.
To copy the selected pump’s settings to one other pump
1. Touch the gray Copy to Pump button next to the green Copy To Single
Pump button.
The keypad pops up.
2. Enter the pump number for the pump you are copying to. Use ← to erase any
mistakes. Use ↵ to enter the value.
The keypad disappears and the Pump Copy screen shows the pump number you
entered under Copy to Pump.
3. Touch the green Copy To Single Pump button.
“Complete” briefly appears at the top of the screen.
4. As appropriate, either continue copying to other pumps, or touch Return to go back
to the Pump n Setup screen.